Zhuhai LED strip wholesale

The LED light strips are generally designed in the grooves on the top, wall, or ground. The light is always blocked and projected and reflected to see good results. LED lights with LED lights with features: 1, low energy consumption, energy saving: power consumption is only 1/10 of ordinary rice bulbs. The power per meter is 3 watts; 2. High safety: high electro-optical conversion rate, close to 100%, low heat generation, no fire hazard; 3. Long life: under normal working conditions, the life span can reach 80,000 hours, up to 5 Years; 4. Strong plasticity: easy to bend and design a variety of shapes to achieve a variety of decorative effects; waterproof, can be used outdoors and indoors; collision-resistant, maintenance-free lamps. Therefore, the effect of LED light source is generally very soft and romantic, and it can have a variety of colors. In addition to enriching the space and lighting, it also has the function of dividing space and highlighting key decorations. With good quality LED lamp beads, the brightness between the lamp beads and the lamp beads is consistent, and the light is uniform, and the brightness of the lamp strip should be consistent at the beginning and the end. LED light belt LED light belt installation, generally use 3M glue to fix. Installed outdoors, often in wind and rain, over time will reduce the adhesiveness and cause the LED light strip to fall off. Therefore, the outdoor installation usually adopts the method of fixing with the card slot, and the place that needs to be cut and connected is the same as the indoor installation. , Just need to be equipped with waterproof glue to consolidate the waterproof effect of the connection point. Then use a special fixing clip to fix it, you can use an electric hammer to drill the eye, use a plastic expansion tube and screw to fix the clip
The light color of the light strip should also be consistent. If you want the light to have a uniform luminous effect, you must choose good color rendering when purchasing. The color rendering index Ra>80 is required for a professional LED light strip. Requirements. This is also a requirement of the national standard GB50034-2013. At present, the application range of LED light strips is wide. The LED light strips produced by regular LED light strip manufacturers are produced by SMT patch technology, using solder paste and reflow soldering processes. Therefore, the solder joints on the LED light strip are relatively smooth and the amount of solder is small, and the solder joints extend from the FPC pad to the LED electrode in a circular arc shape. The counterfeit version of the LED strip has an uneven amount of solder in the solder joints, and most of them appear as a dot to cover the solder feet, and at the same time there will be different degrees of tin tips, which is a typical phenomenon of manual soldering. It is no longer limited to the previous interior decoration, street decoration and other places. In the future, the scope of use of led strips will be further expanded.