Zhanjiang No Dark Zone 3014LED Strip Manufacturer

During the decoration process, the lamp strip selection skills and the decoration effect are reflected. Introduction The lamp strip refers to the LED lamp is welded on the copper wire or strip-shaped flexible circuit board with a special processing technology, and then connected to the power supply to emit light. Named from the light belt. In terms of materials, the 3014LED strip without dark area can be divided into two types: hard strip and soft strip. The advantage of the rigid light strip is that it is easier to fix, and the processing and installation are very simple, but this kind of light strip cannot be bent at will. The soft light strip of flexible material has good flexibility and can be folded and bent at will, but the price is more expensive. During the decoration process, the lamp belt selection skills and decoration effect are introduced. General light strip products provide 3000K and 4000K color temperature for selection. No dark area 3014LED lights with LED lights, generally high voltage 220V, so it is wrapped with a thick layer of flame-retardant glue. Wires, circuit boards, etc. are generally made of copper. LED lights determine the life of the lights. For the sake of electricity safety, you must not choose inferior quality products just because the price is cheap. If you are greedy for temporary cheapness, you may get a safety hazard! Of course, it is not ruled out that you can find good quality and cheap prices, but such an opportunity does not fall out of thin air! Bull LED strip products are available in 3 color temperatures, 3000K, 4000K and 5700K. Hotels, high-end shopping malls and home furnishings can choose a low color temperature below 3000K to create a warm atmosphere; the office can choose a cold light source with a higher color temperature. Try the new favorite of home improvement-LED light strip, no dark area 3014 LED light strip LED light strip is generally 100 meters in a roll, when you choose to buy according to the length you need, how much you order, these should be told to the seller in advance, usually cut it for you of. You need to use several sections at home, each section is equipped with a connector, just plug it directly into the socket. If you want to cut it yourself, you need to pay attention. The light strip will usually be marked with a special scissors mouth, cut it at the scissors mouth, connect it, and you can use it. Remember: be sure to cut according to the instructions, otherwise it will cause no light! Installation is flexible and changeable. How to choose high-quality LED light strips is here-the lighting factory.