Zhanjiang Highlights 2835 LED Strips Quotation

With the development of landscape lighting, LED strips have gradually emerged in the lighting industry because of their long service life and green environmental protection. It has become the new favorite of lighting engineering construction. High-brightness 2835 LED lamp with led lamp with specifications and models. LED size model used: 2835 (2.8*3.5mm) 5050 (5.0*5.0mm); LED color: red, green, blue, yellow, white (warm white, cold White), full color. Number of LEDs per meter: 5, 10, 15, 20, 30, 40. . . Input voltage: 12Vdc, 24Vdc Then, in the process of actual installation and use, sometimes the LED lamp belt is falsely broken, that is, the LED lamp belt is often said to be off. 5630LED lamp with double row highlighting 180 beads, ceiling outdoor waterproof lamp for living room ceiling. The highlight 2835 LED strip has nothing to do with 2538 or 5730. The so-called 2538 5630 refers to the packaging specifications of LED chips. When LED is used to grow grass, the most concerned is the spectrum and luminous flux. Plant growth requires red and blue spectra. Among them, red at 660nm and blue at 540-550 are the most important. As for the luminous flux, it depends on the aquatic species in the grass tank. The new 5630 light strips are imported from Korea. Samsung light source is suitable for high-end clubs, villas, and luxury. Home improvement, outdoor lighting, pure copper wire. The LED strip is generally 220V, so it is wrapped with a thick layer of flame-retardant glue. Wires, circuit boards, etc. are generally made of copper. LED lamp beads determine the life of the strip. Highlight 2835 LED strips. Regular LED strips The LED strips produced by the manufacturer are produced using SMT chip technology, using solder paste and reflow soldering processes. Therefore, the solder joints on the LED light strip are relatively smooth and the amount of solder is not too much. The solder joints extend from the FPC pad to the LED electrode in a circular arc shape. However, the amount of solder in the solder joints of the counterfeit version of the LED light strip is uneven, and most of the solder feet are covered by a dot, and at the same time there will be different degrees of tin tips, which is a typical phenomenon of manual soldering. For the sake of electricity safety, you must not use inferior quality products. If you are greedy for a while, you may get a safety hazard!