Dongguan LED strip manufacturer

Nowadays, the color temperature of LED light strips is very large. Color temperature is a professional concept. The color rendering problem of LED light strips is not very important when the product is applied to indirect lighting lamp tanks. When large-area luminous ceilings are used as basic lighting or used in showcases as display lighting, the color rendering index Ra>80 is a requirement that a professional LED strip must meet. This is also a requirement of the national standard GB50034-2013. Simply put, it is the color of light. As far as white light is concerned, the color temperature is generally expressed in thousands of digits. The smaller the number, the yellower and redder the color, the larger the number, the whiter, and the more blue. The unit is expressed by K. With good quality LED lamp beads, the brightness between the lamp beads and the lamp beads is consistent, and the light is uniform, and the brightness of the lamp strip should be consistent at the beginning and the end. LED light strips LED light strips are generally high-voltage 220V, so they are wrapped with a thick layer of flame-retardant glue. Wires, circuit boards, etc. are generally made of copper. LED lamp beads determine the life of the light strip. For the sake of electrical safety, you must not choose inferior quality products just because the price is cheap. If you want to be cheap for a while, you may get a safety hazard! Of course, it is not ruled out that you can find good quality and cheap prices, but such an opportunity does not fall out of thin air! The light color of the light strip should also be consistent. If you want the light to have a uniform luminous effect, you must choose a good color rendering index when purchasing. The color rendering index Ra> 80 is a requirement that a professional LED light strip must meet. This is also a requirement of the national standard GB50034-2013. How to see the consistency of light color? You can find a piece of white paper, vertically close to the LED light-emitting surface, carefully observe the light and shadow on the white paper, the LED light strip is installed, usually fixed with 3M glue. Installed outdoors, often in wind and rain, over time will reduce the adhesiveness and cause the LED light strip to fall off. Therefore, outdoor installation often adopts card slot fixing method, and the place that needs to be cut and connected is the same as indoor installation. , It just needs to be equipped with waterproof glue to consolidate the waterproof effect of the connection point. Then use a special fixing clip to fix it, you can use an electric hammer to drill the eye, use a plastic expansion tube and screw to fix the clip
The LED light strip can judge whether the light color is the same. Isn't it simple?