recessed lighting how to paint recessed lights | ehow

Embedded lighting is used from creating ambient lighting to illuminating corridors and even home theaters.If your embedded fixture is brokenof-Date or wear, or if you are changing the color of the wall and ceiling and want the lights to match or complement the new color, the decoration and bulb packaging can be easily painted with hot paintPaint resistant.Heat-Paint-resistant has a variety of colors, as well as artificial paintmetal finishes.Turn off the main circuit in the circuit breaker to the lighting device you will be using.Remove the bulb and then remove the decoration of the package lamp.Usually the decoration is connected by a spring or clip and can be easily pried out of the ceiling.Use a screwdriver to unscrew the screws in the package and pull them out slightly from the ceiling and unscrew the wires of the lights from the wires in the junction box.Place the decoration and packaging on the working surface, protect with newspaper if necessary, place in the wellVentilation area.Lightly Polish parts with 400-Make sure the primer is properly bonded with sandpaper.Wipe with a sticky cloth to remove the sanding dust.Paint with a hot light coating-Spray resistant primer.Use the sweeping action to keep the nozzle at least 12 inch from the surface.Do not let the primer pool or drip.Allow the first coat to dry, and then add one or two light coats as needed for a uniform coverage.Let the last coat dry.Light sand with 800-Polish with wet sandpaper to ensure proper adhesion of the paint.Wipe the parts with a sticky cloth to remove the sanding dust.Paint with a hot light coating-Paint resistant.Use the sweeping action to keep the nozzle at least 12 inch from the surface.Do not let the primer pool or drip.Allow the first coat to dry, and then add one to three light coats as needed for a uniform coverage.Let the last coat dry.Paint with one to two layers of light colorResistant clearcoat creates a protective and glossy finish on the paint.Let the transparent coating dry.Reconnect the lights to the ceiling.When wiring the lights, remember to match the correct wires (black to black, white to white and ground to ground ).