Maoming LED strip manufacturer

In fact, people without relevant knowledge and experience are easily deceived and buy low-quality light strips. However, experienced people still have a way to identify, the LED light strips produced by regular manufacturers and the LED light strips of cottages can be seen at a glance from the appearance. The color rendering problem of LED light strips is not very important when the product is used in indirect lighting lamp troughs, but when used in large-area luminous ceilings as basic lighting or used in showcases as display lighting At that time, the color rendering index Ra>80 is a requirement that a professional LED strip must meet. This is also a requirement of the national standard GB50034-2013. The following Shenzhen Lighting Factory introduced us to the identification techniques of the quality of LED light strips, to see how to identify the quality of LED light strips by eyes. With good quality LED lamp beads, the brightness between the lamp beads and the lamp beads is consistent, and the light is uniform, and the brightness of the lamp strip should be consistent at the beginning and the end. The quality of the FPC depends on the LED lights. FPC is divided into two types: copper and rolled copper. The copper foil of the copper-clad board is protruding. If you look closely, it can be seen from the connection between the pad and the FPC. The rolled copper is closely connected with the FPC and can be bent at will without the phenomenon of pad falling off. If the copper-clad board is bent too much, the pad will fall off. If the temperature is too high during maintenance, the pad will fall off. The light color of the light strip should also be consistent. If the lamp has a uniform luminous effect, it is necessary when purchasing Choose good color rendering, color rendering index Ra>80 is a requirement that a professional LED strip must meet. This is also a requirement of the national standard GB50034-2013. Only those who are kind to life will be treated kindly to life. LED strips have to be connected and used. The length of each strip can be connected, which has a lot to do with the width of the circuit and the thickness of the copper foil when designing. Because the current intensity per unit area is related to the cross-sectional area of u200bu200bthe line, if this is not considered when wiring, then when the connection length exceeds the current that the line can withstand, the light strip will heat up due to overcurrent. While damaging the circuit board, it also reduces the service life of LEDs. Choose lighting factory light strips, arrange smart light strips and LED light strip controllers, and bid farewell to dazzling ceiling lights. Every night, when you sit up from the bed, it will automatically light up and take care of you and me tenderly!