Chaozhou highlight 2835 LED strip design

The reason why LED lighting is popular is not only because it saves electricity, but also because it can produce beautiful effects in every residence. It is difficult not to use LED in modern design. The color rendering problem of the highlight 2835LED strip LED strip is not very important when the product is used in indirect lighting lamp troughs, but when used in large-area luminous ceilings as basic lighting or used in showcases as a display When lighting, the color rendering index Ra>80 is a requirement that a professional LED strip must meet. This is also a requirement of the national standard GB50034-2013. Today, Shenzhen Lighting Factory gives you some suggestions and examples about LED strips. Take a look at the suggestions below to get some new ideas for your own decoration design. When it comes to LEDs, energy saving is naturally its due. Highlight 2835LED strips currently commonly used LED strips are 3528 and 5050 strips. On the one hand, the difference between the two is the size. On the other hand, there are 3 LED chips in the 5050 lamp beads, while there is only 1 LED in the 3528. Chip, therefore, under the same number of beads, the brightness of the 5050 LED strip is 3 times that of the 3528 LED strip, the power is also 3 times, and the price is more expensive. For LED strips, the importance of light efficiency is the same as it The application scenarios of the luminaire have a lot to do. The requirements for light efficiency are relatively low when applied to large-area luminous ceilings or display cabinets. As a professional LED strip, under the premise of color rendering index Ra> 80, the light efficiency should be at least 60 lm/W. Only by using LED downlights and other lamps to create a moderate and comfortable lighting environment can we inspire the spirit of a family! For a comfortable light environment experience, the number of lamp beads per meter of the high-brightness 2835 LED lamp belt is fixed. 1210 is 60 lights, 5050 is 30 lights. If there are special requirements, if there are 50 lights per meter, it is necessary to modify the circuit. Usually it is a group of 3 LEDs. If it is 50 lamps, there will be a group of insufficient quantity, but if it becomes a group of two LEDs, the resistance of the current-limiting resistor will be increased, which will cause a waste of resources. Therefore, when customizing LED strips, it must be noted that the number of lamp beads is a multiple of 3, which is always inseparable from the outline of the auxiliary light sources of LED strips. The above is the complete guide for the use and installation of LED light strips taught by Shenzhen Lighting Factory Company. Thank you for taking it away!