Chaozhou 3014LED flexible light bar manufacturers

The light strip is generally installed in a dark groove, showing 'seeing the light but not the light'! Can make the space highlight the sense of hierarchy and increase the artistic conception! 3014LED flexible strips The LED strips produced by the regular LED strip manufacturers are produced by SMT patch technology, using solder paste and reflow soldering processes. Therefore, the solder joints on the LED light strip are relatively smooth and the amount of solder is small, and the solder joints extend from the FPC pad to the LED electrode in a circular arc shape. However, the amount of solder in the solder joints of the counterfeit version of the LED light strip is uneven, and most of the solder feet are covered by a dot, and at the same time there will be different degrees of tin tips, which is a typical phenomenon of manual soldering. The true appearance of the light strip is like a belt. It uses an LED light source. As the name suggests, it is called an LED light strip. It can be turned on by directly connecting to the 220V mains. It is fixed with a fixed card and it is not difficult to install. LED specifications: Ultra-bright SMD LED light color: 3014LED flexible light bar The commonly used LED light strips are 3528 and 5050 light strips (3528 refers to the size of the LED light source, length 32mm, width 28mm, and 5050 refers to The length and width of the LED light source are both 50 mm). On the one hand, the difference between the two is the size. On the other hand, there are 3 LED chips in the 5050 lamp beads. Therefore, under the same number of lamp beads, the brightness of the 5050 LED lamp strip is 3528 LED strips. 3 times. Red/yellow/blue/green/cool white/normal white/natural white/warm white/RGB/special color/special color temperature, power supply, controller and other ancillary products can be provided. To do a good job of LED light strips need to include various factors such as craftsmanship, technology, and service. 3014LED flexible light bar LED light strip installation, generally fixed with 3M glue. Installed outdoors, often in wind and rain, over time will reduce the adhesiveness and cause the LED light strip to fall off. Therefore, the outdoor installation usually adopts the method of fixing with the card slot, and the place that needs to be cut and connected is the same as the indoor installation. , Just need to be equipped with waterproof glue to consolidate the waterproof effect of the connection point. Then use a special fixing clip to fix it, you can use an electric hammer to drill the eye, use a plastic expansion tube and screw to fix the clip
Many companies will choose to abandon the production of this product because of short-term profit considerations. The lighting factory is not afraid of hardships and marches forward courageously on the LED light belt.