paint brass chandelier how to spray paint brass light fixtures | ehow

Did you find yourself in the middle of the renovation project and can't stand the old brass fixtures for a minute?Maybe the problem is that you like the style of the fixture, but hopefully it's a different color.The solution is simple and does not require much time and money.After a few hours, you can completely change the look of the brass light fixture with paint.Remove all parts of brass lamps that do not wish to be painted.If the fixture is in use, it must be removed, or you must take precautions to protect the ceiling and walls and provide adequate ventilation for the smoke.To remove the light fixture, turn off all power supplies.Remove the board that covers the wire and unlock the fixture.For easy re-wiring, you may need to mark the wire when you disconnect it.Clean the brass lamps with detergent and water to remove dirt and gently polish off any signs of corrosion with fine sandpaper.Rinse well.Avoid getting wet the socket area (where the bulb and Globe are plugged in.Let it dry thoroughly before painting.By packing each piece of work with the adhesive tape of the painter, the sockets and wires of the brass lamps are protected from paint.It also saves you time because you don't have to be so careful around these reserves.Install the brass lamps before painting.Hold the tank 4 to 6 inch from the fixture and spray the primer with a small amount of paint instead of a continuous paint stream to help prevent it from running.Apply a light color paint on the entire fixture and finally the most visible side.Allow for thorough drying.Spray the color of your choice on the primer by holding the tank 4 to 6 inch from the brass fixture and then spray the paint with a small amount of paint instead of a continuous stream.The technology will help keep the paint running.Apply a light paint on the entire fixture and allow for a thorough drying.Paint the second layer if needed.Allow for thorough drying.