The maintenance method of the floor lamp in the living room is mainly to prevent moisture and dust. What do you do?

by:EME LIGHTING     2021-03-22
1. The best consideration for moisture-proof electrical appliances is moisture, which will not only have a shorter lifespan, but also have electricity risks. Therefore, the key to maintenance of floor lamps is to prevent lakes, whether it is placed in the living room, the lighting in the bathroom, the classroom and the kitchen. The front lamp of the stove must be equipped with a protective lampshade to avoid moisture intrusion and promote the appearance of rust damage or leakage short circuit of the lamp. 2. Dust removal The maintenance of the floor lamp requires frequent dust removal, especially the lampshade of the floor lamp. The lamp can be darkened by simply pushing the dust layer, which affects the lighting, so it should be cleaned frequently. When tidying up the lampshade of the floor lamp, use a clean feather duster to remove the dust. Do not deform the lampshade. There are several conditions for floor lamp dust removal and scrubbing: (1) You can use a clean feather duster to remove the dust as usual, so be careful. (2) If it is a non-metal floor lamp, it can be wiped clean with a damp cloth. Be careful not to wipe the power cord. (3) If it is a metal lamp, wipe it with a dry cloth, and don't touch it with water. Note that when cleaning and protecting, you must disconnect the connected power supply. At the same time, be careful not to change the structure of the lighting, and do not replace the parts of the lighting at will. After the cleaning and protection are completed, the lighting should be installed as it is. Don't install or spare lighting parts. Avoid creating risks. If you don’t need water, please wash the tools, just wipe them with a dry cloth dampened with water. If you don’t care about touching the water, try to wipe them dry as much as possible. Always wipe with a damp cloth immediately after turning on the light. 3. Do not switch frequently. Try not to switch on or off with frequency when using the lighting. Because the current through the filament is greater than the current during normal operation when the lighting is frequently started, the temperature of the filament will rise sharply and continuously increase, which will greatly reduce Its service life, this is also a point that should be paid attention to in all lighting maintenance.
Custom message
Chat Online 编辑模式下无法使用
Leave Your Message inputting...