Mastering the installation method of all copper lamps is safe and convenient
The birth of lamps originated from human's demand for life. The Early lighting lamps were relatively simple, that is, the oil lamps at that time. This seemingly simple shape laid the foundation for the bend candle lamps in all-copper lamps today, however, no matter from appearance, function or environmental protection, all-copper lamps have gradually changed from the initial single practicability to the combination of practicality and decoration.
Then, due to the characteristics of the size and weight of all-copper lamps, the installation has become a confusion for consumers. In fact, proper installation of all-copper lamps can also bring a lot of convenience to our maintenance.
Lighting and lampshades should be well ventilated to prevent the temperature from rising continuously due to the inability to dissipate heat, which will affect the service life of the light source. The light bulb weight do not more than holders together with load. Energy-saving lamps (Especially the old inductive type)
It is larger and heavier than ordinary tungsten filament bulbs, so when switching to energy-saving lamps, attention should be paid to the size matching with lampshades or lighting.
At the same time, attention should also be paid to whether the lamp holder, especially the multi-bulb type all-copper lamp, can support the weight of the bulb.
If the lamp holder is found to be loose, it should be replaced or repaired immediately.
When installing a full copper lamp, if you install a sub-control switch, you can save a lot of troubles.
Because if there is only one main switch and several lights are on and off together, the light and shade of the light cannot be selected, and electric energy will also be wasted. However, when the sub-control switch is installed, several lights can be selected at any time according to needs.
If there is an aisle at the entrance of the house, it is best to install a switch at the end of the aisle, so that the power can be turned off directly after entering the door, and there is no need to go back to the door to turn off the lights.