hampton bay lighting how to install a hampton bay exterior wall lantern light ...

Installing Hampton Bay decorative wall lights on the outside of your home not only enhances the look of your home, but also increases the security around your home.The lanterns mounted on both sides of the front door give you enough light to open the door at night and see the close visitors clearly.Installing lanterns on both sides of the garage will illuminate your driveway and stop intruders.Turn off the circuit breaker inside the circuit breaker panel to power the current exterior wall light.Remove the screws that hold the current light on the external junction box.Take the lamps from the box and reveal the wires in the box.Unscrew the wire connector from the wire inside the junction box, disconnect and remove the light from the wall.Assemble the Hampton Bay exterior wall lanterns according to the instructions provided by the equipment.Attach the fixture beam with wall lamp mounting hardware to the external junction box with the screws attached to the mounting hardware.According to the style of the lantern, the beam is 4-An inch metal circle with several holes, a 4-inch by 1-Metal plate with several holes or two 4-inchinch by 1-An inch metal plate connected to the center to form a cross.The number of holes on the bar may vary.Connect the wiring of the junction box to the Hampton Bay exterior wall lantern.Match the white line on the lantern with the white line on the junction box.Twist the Orange wire connector to both wires and connect them together.Repeat the connection to the black line on the lantern and the black line on the junction box.Connect the green wire on the lantern to the bare copper line on the junction box with another Orange wire connector to complete the wiring connection.Connect the Hampton Bay exterior wall lantern to the junction box or fixture beam.Depending on the design style, you can connect the lantern with the screw directly to the junction box, connect the lantern to the fixture beam with the mounting screw, or install it on the two screws permanently attached to the beamWhen installing the lamp to the mounting screw attached to the beam, twist the mounting base to both screws and fix the lantern to the wall with a threaded nut cap that matches the lantern finish.Fill the seam around the lantern mounting base with transparent silicone to prevent moisture from penetrating into the junction box from behind the lantern.Open the circuit breaker inside the circuit breaker panel to power the Hampton Bay exterior wall lantern.